Additional elements – Maxproduct

Upper valley plank

ravshan687 — Fri, 09 Sep 2022 10:28:05 +0000

The upper valley is a roofing element in the form of an internal corner, located at the junction of the roof slopes.

Complicated internal corner

ravshan687 — Fri, 09 Sep 2022 10:26:48 +0000

Internal corner plank used to finish the internal corners of the facade of the building, mainly at the junction of walls and roofs.

Plain docking bar 60mm

ravshan687 — Fri, 09 Sep 2022 10:24:33 +0000

A simple docking bar closes the joints of profiled sheets along the entire length, protects against loosening of fasteners and sheets being torn off by gusts of wind

Plank near-window complex

ravshan687 — Fri, 09 Sep 2022 10:22:54 +0000

The window trim is a special element designed to finish the slopes and hide the cut edges of the panels.

Internal corner plank

ravshan687 — Fri, 09 Sep 2022 10:21:21 +0000

The inner corner plank used for finishing the inner corners of the facade of the building has a decorative functional component, which gives an aesthetic and attractive appearance to the joints of various corrugated boards at the corners, while ensuring competent and reliable sealing of the joint. It is mainly used at the junction of walls and roofs, chimneys and roofs.

Plank initial

ravshan687 — Fri, 09 Sep 2022 10:19:22 +0000

The starting or initial siding bar is the element from which the wall cladding begins. It is installed with the top edge along a pre-marked horizontal line located 40 mm above the bottom border of the trim. Subsequently, the siding panel is inserted into the starting bar with its lower edge, and the upper edge is attached to the wall or crate.

End plate PE 80×100 mm

ravshan687 — Fri, 09 Sep 2022 10:17:51 +0000

The end strip, thanks to polymerization and attractive appearance, creates an impeccable aesthetic and beautiful design for the facade of the building, protecting the roof from wind load, moisture, etc.

Outflow simple 150 mm

ravshan687 — Fri, 09 Sep 2022 10:15:26 +0000

A simple low tide is a bar that is installed from the outside of the building to provide protection from precipitation.

Frontal plank 190×50 (roofing)

ravshan687 — Fri, 09 Sep 2022 07:15:56 +0000

The front plate protects the front board from moisture and serves as an additional support for the drain clamps and the filing of the cornice part of the roof. It is fastened before installing the cornice strip with self-tapping screws with a pitch of 35–40 cm and an overlap of at least 5 cm.

External corner strip 30×30 mm

ravshan687 — Fri, 09 Sep 2022 07:14:12 +0000

The outer corner bar acts as a decorative element that gives an aesthetic appearance to the joints.